i picked this little thing up from a charity shop for a quid! voices of 5 animals making strange animal sounds after. ive only found one bend but its dubious as it needs constant resetting. anyone bent one of these before? i was curious if it was easy to find a pitch point or if you need an ocsilloscope, thanks guys! any help is well appreciated cos ive been fiddling all day with not much luck! ive read as much as i can about the processes of circuit bending and i want to find stuff out for myself (im like that!) but not much is happening! cheers
a moist finger will be enough to find a pitch control if it is resistor based. just dampen your finger and start touching all the resistors you can see on the circuit board whilst the thing is making sounds.... when you find one that causes the animal noises to shift pitch you can cut it out and replace it with a pot, probably a 1meg one but milage might vary depending on the stability of the circuit at higher or lower settings....
is there a chicken noise on there? i need to find a bendable chicken noise at the moment... hmmmm....
is there a chicken noise on there? i need to find a bendable chicken noise at the moment... hmmmm....
I got both a chicken and a duck on the farmyard fun toy just sold on the SHOP - TOYS page of the circuitbenders site. I can sense your jealousy from here
excellent! thats awsome cheers! no sorry no chicken. got a bear that sounds like its getting raped though, and thats before id done anything to it! yeah it is resistor based, one big chip. im having trouble actually, i found an awspme glitch but its very intermittent, i do the same thing over and over and it only does it once every so often. any ideas? also wheres the best place to get different pots from? music shops are way too expensive! ive take to robbing out of my own guitars!
...yeah it is resistor based, one big chip. im having trouble actually, i found an awspme glitch but its very intermittent, i do the same thing over and over and it only does it once every so often. any ideas?...
You could try some small value resistors or capacitors between the glitch points. Sometimes a 200 ohm res is all that it takes to make a glitch that little more stable.
Author
Logged
