Wow! Thanks a lot for your reply. However, my first bending experience wasnt that good so far O_o
I tried installing the voltage drop. Got myself a 1K Potentiometer, and cut the small wire next to the speaker cables.
The potentiometer has 3 points to connect, so i routed one to the middel, and one to the outer right. After failing to wrap the cable ends to each other, i tought that soldering would be a good idea. However the main board of the SA1 doesnt seem to hold any of my solder, and i also burned one end of the wire i cut....Wich end up in a 2MM wire, wich will be hard to connect with a wire now, lol.
Basic question is, is the routing of the wires good? (i know: very basic knowledge this is, but i lack of that!)
I tried it, on the kick ass demo song afcourse, but as soon as i turned the knob of the potentiometer a little bit, the machine just died without making noise. Ok: i admit that there was a little bit of noise, but the volume was sooooo low that no-one ever can notice that. If this is the so superfamous-SA-Lowvoltage-drop....then you guys suck ..lol
Next to that, how to install the other mods and what do they do? And are there some interesting body contact points??
Thanks in advance,
If someone likes to help, you can add me under sandervw_@hotmail.com in MSN messsenger!
Ok bye!