Hey paul, I'd like your expert opinion!
So I found about 25 bends in the Cheetah, picked the 16 most interesting ones.
Also tried to pick the more stable ones, cuz when the Cheetah crashes it crashes quite badly garbled display & stuff so then you need to cold start it.
Put in a patchbay, connected the 16 bends & a reset switch.
Closed it up, worked normal. Quickly tested all the patchbay connections. All were doing something.
So, I set it up for a serious glitch session with MIDI going into it. But as it turns out it crashes pretty much with every connection...
Had a quick look inside again, all the wiring seems OK (but will double check tomorrow)
What do you think it could be? It was fine when I was manually shorting pins with a piece of wire.
Cheers!