Hi guys!
I'm a first time bender but an above average solder.
I just purchased a 2012 furby so i can start tinkering with it.
I need tips how to get started.
What i want to do is:
-Pause switch. (What ever it's doing, it pauses it and then resumes where it was left)
-Volume/speaker pitch knob. (Probably going to buy a volume knob and solder it in so i can change the pitch)
-Simple on off switch to cut the power. Probably going to just use the original on off but extend it.
-Speed controller faster and slower.
-Weird glitchy stuff?
-If possible, i want to control the LED display eyes to make them do weird stuff
-If possible, record and playback custom sounds?
All switches will be mounted in a controller box that is wired to the furby.
If possible, original fur will be mounted back to make it seem normal..
Also if you guys could explain the mechanics and how it actually works and where to solder on to?
I have a multimeter so if i need certain voltages or resistances, i can measure them to get it correct.
Thanks!