So, how does that work then... for example, using an exacto knife? Do you just slice along the lines and that is enough to separate them, or do you have to do like two cuts next to each other and then with the tip of the knife, carefully pick-out (or lift away) the remaining bit of line between the cuts? In other words, would a single slice be good enough?
Also... once the lines are rewired and switches have been placed on them, would there be any benefit in creating a patch bay to mix those data lines around? I mean, can data from one line be redirected to another line instead of just being switched on or off? Again, the obvious answer to me would be 'yes', but has anyone experienced success with using a patch bay for the data-line cut mod instead of the standard on/off toggle?