Circuitbenders Forum
Circuitbenders Forum => Circuitbending discussion => Effects Units => Topic started by: electoyd on July 12, 2010, 10:16:44 PM
-
just opened up one of these last night, got a few nice bends on it, i put a pot and a couple of switches on it there's quite a few more bits though, they turn the phase into a really deep bassy rumble, quite nice. Seemed to be mainly one spot that was causing alot of the goings on.
-
I was going to open up my PH-1 the other day, until i noticed that for some reason poeple pay over £100 for them on ebay.
Not really a very useful contribution to this thread but i thought i'd mention it ;)
-
thats very steep :o i've now put a 5 way switch, a single switch and a pot with a 2 way switch on it, there is a few nice points on it, more of a noise creator/effector now. I'm doing it as a pressie for someone that is going to put a guitar through it. They have a small trimpot inside them that you can bring outside not exactly sure what it changes but gonna give it a try, it's just in a really awkward place. I would say if your working on one of these be very careful with the circuit traces, maybe glue any wires down save the wire getting tugged, i had a trace come up and had to retrace it.