Recently started building some synths and when I found my old "toy" keyboards in the garage I started reading about circuit bending. Started with my SK1 (up next are Casio Mt31, Casio CT380, Rapman, alesis hr16
)
Itīs not finished just yet cause Iīm waiting for some parts (pots, midi etc.) I will also make a panel where the speaker was to hold the audio out, midi in and maybe power (might place in the back). Iīm thinking about the phat filter mod also or maybe a seq (placed in the emty space above preset switches).
So far it has:
- 28 patches in patchbay with 4 helper/preset switches and 4 helper/preset pots.
- 25 preset switches
- filter bypass (on-off)
- poly voice pot
- pitch pot (not working with 500k pot...will try lower res and a resistor)
- drum mute switch
- soft reset switch
It makes beautiful noise
Will try to make a video when itīs finished.
iīve learned alot so far from building it like I will only use single core wire from now on and I will always check switch/pot orientation before soldering....