Circuitbenders Forum

Circuitbenders Forum => BENDING TIPS => Circuitbending discussion => Repair advice & questions. => Topic started by: littlejon64 on April 03, 2011, 05:15:28 PM

Title: LM386 Amp kit
Post by: littlejon64 on April 03, 2011, 05:15:28 PM

having trouble
Bought a low voltage amp kit online from kitsrus kit #17
I am having trouble finding where on of the capacitors goes C3 in the kit
in the circuit it says from pin 7 to ground but there is no spot on circuit board can you assist me this is my firt time making a circuit
Thanks
Jon

Title: Re: LM386 Amp kit
Post by: Circuitbenders on April 03, 2011, 05:32:08 PM

if theres no space on the board for it then it might have been taken out of the design and is no longer necessary.

On the other hand you could always just add it on the solder side of the board going from pin 7 to the battery negative terminal, or pin 2 of the LM386, or pin 4. They're all the same ground.

Title: Re: LM386 Amp kit
Post by: Gordonjcp on April 04, 2011, 09:26:07 AM

Can you post some pics of both sides of the board, so we can see what you're on about?