Circuitbenders Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Author Topic: Zoom 1201 clock modification  (Read 110 times)

Northernexpermentsinsound

  • Newbie
  • *
  • Karma: 0
  • Offline Offline
  • Posts: 4
Zoom 1201 clock modification
« on: August 22, 2021, 06:20:35 PM »

Iíve got a Zoom 1201 and would really like to do the  clock modification , Iíve had the ltc1799 for a while now and I think Iíve finally plucked up the courage to give it a go.  I think Iíve found all the points but if any one could let me know if they are correct Iíd really appreciate it. Iím also not sure where to solder the output of the ltc1799, does it just go to the where the middle leg of the crystal/ xtal is when I remove it ?

 I couldnít attach any photos to my post so had to stick them up on imgur.

https://imgur.com/gallery/HSmDgx1

https://imgur.com/gallery/G87AgfN
Logged

Circuitbenders

  • crustypaul
  • Admin
  • This person is dangerously insane.
  • *****
  • Karma: 1102
  • Offline Offline
  • Posts: 2451
    • Circuitbenders.co.uk
Re: Zoom 1201 clock modification
« Reply #1 on: September 21, 2021, 07:22:54 PM »

The middle leg is ground, you need to use one of the outer legs to inject the LTC1799 signal. We usually use the one furthest from the front panel.

You can source +5v and ground from the voltage regulator. The middle regulator pin is ground.
Logged
i am not paid to listen to this drivel, you are a terminal fool