Circuitbenders Forum > Circuitbending discussion

labelly-type-things...

(1/2) > >>

geigercounter120:
Hello again!
I am getting into this whole circuit bending name now.. and I'm thinking about how my completed project is gonna look.  I wan to add some labels to it, similar to what I've seen on this item on ebay (it's probably being sold by someone here tbh!):

http://cgi.ebay.co.uk/ORANGE-Circuit-Bent-YAMAHA-PSS-140_W0QQitemZ280008810309QQihZ018QQcategoryZ38071QQrdZ1QQcmdZViewItem

I was wondering if someone could tell me the name/link of a kit I can use to create some of these myself, or if anyone has any cooler ways of naming their buttons!?

Cheers guys/grrlz

Chris

 ;D

Circuitbenders:
I think those are done using a Dymo embossing label writer. They were made in the late 70's and 80's if i recall correctly but i'm not sure if you can still buy them, you can still get the embossing tape so i'd imagine you can.

geigercounter120:
cheers for that!
searching for 'label makers' on t'interweb wasn't too helpful!

the_zombiest:
They still sell the Dymo machines at staples and other stationary suppliers... only now they're in jazzed up colours such as lime green and sky-blue. 
They're still a big pain in the arse too :)

gmeredith:
Letraset make a really stylish set of rub-on lettering:

http://www.letraset.com/shopdisplaycategories.asp?id=17&cat=Rub+Down+Lettering&ssctn=default

I've had some of these sheets for years. The big advantage of them is that they're completely flush with the surface they sit on, so they actually appear to be printed on the surface, like the rest of the lettering on your keyboard. You can get them in black letters and I think also white. You just use a smooth blunt object, such as the round back end of a ball point pen, by laying the letter sheet on the surface to be printed on, then you rub the letter you want with the blunt object, reasonably hard. Then carefully peel off the sheet from the letter, and the letter stays there. You then make up the rest of the word you want, 1 letter at a time, in the same manner.

Cheers, Graham

Navigation

[0] Message Index

[#] Next page