I recently may have lost a SA-5 because of my technique that I use so I wanted to ask others what their technique is. WHen I bend, I make the two connections wire up the switch, and then just push it to the side and go on with the other bends. At the end of a project I end up with a huge jumbeled mees of wirees, switches and buttons, that I usually need to untangle, mount the switches, and then reconnect. Reflecting on this messy technique - I think that I may be causing a dangerous situation because of all of the wires and siwtches crossing, this may cause something that is not good (i.e. death to the device). So I am asking, how do you go about wiring up a device? DO you wire each switch and then mount one at a time? ANy tips or suggestions?