Topic: Adding a tele output (Read 8613 times)

Källman · « **on:** December 05, 2007, 11:20:36 AM »

Just done my first bend and the obvious questions about different sound outputs popped up.

Is there a way to add a tele output jack into a toy? Is the signal to week? Are there any alternatives?

Awesome place btw.

Circuitbenders · « **Reply #1 on:** December 05, 2007, 03:24:51 PM »

tele output jack?

is this some technical term i'm not aware of?

Källman · « **Reply #2 on:** December 05, 2007, 06:54:04 PM »

well tele is the format most guitars use. tele is what we call it in sweden, so im probably using the wrong words here.

the end of the cable, whats it called? cant find a good word for it

Circuitbenders · « **Reply #3 on:** December 05, 2007, 07:14:18 PM »

1/4 inch jack is the term you're after i think.

Usually you should be able to wire the speaker terminals from a toy to a mono jack socket to create a line out. + to tip and - to sleeve although it doesn't matter to much which way round they are. If the out output is to high use this circuit to calm it down a bit

a higher value of R1 will give a lower output.
Theres all kinds of problems you can come accross with outputs but a lot of them have been covered on this forum so do a search.

Källman · « **Reply #4 on:** December 05, 2007, 08:53:27 PM »

I tried searching for it but found nothing. But then again, i didnt know the words for it. Thanks alot for the info tho!

Circuitbenders Forum

News:

Author Topic: Adding a tele output (Read 8613 times)

Källman

Adding a tele output

Circuitbenders

Re: Adding a tele output

Källman

Re: Adding a tele output

Circuitbenders

Re: Adding a tele output

Källman

Re: Adding a tele output