Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[stolenfat]

One of my favorite noise sounds is a signal bit crush (lower sample rate) then flowed toward a ring mod.  I was pondering building a stand alone unit that could have a Bit crusher circuit linked to a ring mod circuit through DIY resources.  I know theres plenty of ring mod DIY's out there but im not to sure about bit crushing, because perhaps its only a digital process.  Any one out there have any good resources i could check out or some ideas for me?

[Silas]

Have a look at this...

http://www.getlofi.com/?p=626

[stolenfat]

woah cool, thanks for the link, pretty slick
i think integrating one of those sample reduction circuits with a ring mod would be totally fat noise pedal, great project idea for down the road.
Any idea where i could get some cheap PCBs made, i've read up on making some at home but dont have access to the chemicals needed.

[Silas]

Sure you can.. Have a look at this too.. http://www.instructables.com/id/The-Saltwater-etch-process/?ALLSTEPS

P.s: Don't forget the karma button 

[Gordonjcp]

The GetLoFi project uses a fairly difficult-to-get chip.  You could make just as good a sample-and-hold with a 4066 analogue switch.  Have a look for various old analogue synth circuits.